Cleanup focuses on the closet, not the machine. The crew removes moldy drywall and platform material around the unit, cleans the framing, dries the closet and the slab, and cleans the return opening and grille area. Coil cleaning, drain repairs and duct work are done by a licensed HVAC contractor, ideally while the closet is open.
Your air handler pulls gallons of water out of the air on a humid day and sends it down a condensate line. When that line slows down, the water ends up on the closet floor, the wood platform and the drywall around it. Add a return grille that draws air across those damp surfaces, and the closet becomes a steady place for growth.
New Kingston's part of the job is the closet itself: the walls, platform, floor and return area around the unit. The AC system, its coil and its ductwork belong to your HVAC contractor, and we work around that line on purpose.

Why the AC closet grows mold before any other room
In Miami the AC runs most of the year, and NWS Miami notes that dew points stay above 70 degrees from about late May to mid October. That means the air handler is pulling a lot of water every day, and all of it passes through one pan and one small pipe inside a tight closet.
Algae growing in condensate pans and traps can clog the drain line. Water then spills from the primary pan into the closet unless a secondary pan or a water-level shutoff switch catches it, and forensic investigators have traced water damage claims to exactly this clog.
The closet is also warm and still, and if the door has a louvered return, the unit pulls house air across those damp walls all day.
Where our cleanup ends and HVAC work begins
We remove and clean what surrounds the system: closet drywall, baseboard, the wood platform or stand, the floor, and the framed return opening and grille area. That is building material, and it follows the same containment and removal approach as any mold remediation job.
The air handler, the evaporator coil, the blower, the drain pan, the condensate line and the ductwork are part of the AC system. Cleaning a coil, clearing or rerouting a drain and replacing duct sections is work for a licensed HVAC contractor. We coordinate timing, but we do not service the equipment.
- Our crew: closet walls, platform, floor, return framing and grille area
- Your HVAC contractor: coil, blower, pan, drain line, ducts
- Both: a shared schedule so the closet is open only once
