If storm water or a roof leak has soaked your Boca Raton home, dry it fast. EPA advises drying wet materials within 24 to 48 hours to keep mold from starting. Call and we will extract the water, dry the structure, and if mold has already grown, contain and remove it. Testing and clearance are done by an independent licensed mold assessor.
Boca Raton is the southernmost large city in Palm Beach County, with the Hillsboro Canal marking its border with Broward. The median home was built in 1985. Housing ranges from a few 1920s Mizner-era Mediterranean buildings to golf-community villas in Boca West, 55+ communities such as Whisper Walk, Boca Gardens and Century Village, and downtown condos built between 1999 and 2020.
Crews drive up from the Miami office, about 45 miles south. Most Boca Raton jobs start with a roof leak or a storm and end with drying and mold removal, so we plan for both from the first visit.
Barrel-tile roofs and slow leaks
Most Boca West homes were built in the 1970s and 1980s with barrel-tile roofs. A tile roof can look fine from the street while the underlayment beneath it has worn out, so water reaches the decking a little at a time. By the time a ceiling stains, the attic insulation and roof sheathing may already be damp and growing mold.
We check the attic, ceilings and walls with moisture meters, remove what is wet, and dry from the top down. If mold is on the roof decking, see attic mold removal for how that work runs. Your roofer handles the roof itself.
Storms this city has seen
Boca Raton was hit by the October 1947 hurricane, by Frances and Jeanne in September 2004, by Wilma in October 2005 and by Irma in September 2017. Much of the city lies within a FEMA Special Flood Hazard Area, so buyers with federally backed mortgages must carry flood insurance.
After a storm, we tarp damaged roofs, board broken openings and extract water before drying. For homes with several kinds of damage, our hurricane damage restoration covers the full sequence from securing the house to rebuilding.
- Photograph the roof, windows and every wet room
- Move rugs and furniture off wet floors
- Run the AC to pull humidity down if power is on
- Call before drywall and padding start to smell musty
Removing mold the right way
Our mold remediation work starts with fixing the moisture source, because mold returns if the water does. We set up containment with plastic sheeting and negative air so spores do not spread to clean rooms, remove the growth and damaged materials, clean what stays and dry the area before rebuilding.
Florida law separates mold assessment from remediation, and the same company may not do both on one structure. If you want air or swab testing, or a clearance check after we finish, hire an independent licensed assessor. We work from their findings.
